Thermal image
Connect the Melexis IO board with an MLX90642 on I2C.
——
Min—
Centre—
Max—
Device
- Status
- Disconnected
- Chip ID
- —
- Firmware
- —
- Refresh rate
- —
- Output format
- —
- Measurement
- —
- Emissivity
- —
- Ambient (Ta)
- —
- Frame
- —
7-bit, 0x08 to 0x77. Detect passes the address it found; the last one used here is
remembered. Applies on the next connect.
Display
SCPI log
Configuration is read-only here. Refresh rate, emissivity and output format are stored in the sensor's EEPROM and written through a dedicated command shape that is documented in the datasheet rather than in the driver library, so this page reports them but does not change them.